Our machines offer a longer lasting life span, lower cost, and less frequent maintenance.

Tumbler media is the abrasive used in mass finishing that grinds away the burrs and cutting lines on a metal surface. Tumbler media comes in many shapes and forms.

A polishing machine smoothens the product's rough edges, increasing its technical and aesthetic value...

Mass finishing can be done either dry or wet with a centrifugal bar tumbler. Wet processes employ a liquid cleaner, lubricant, or abrasive while dry processes don't. Each barrel holds approximately 50-80% capacity.

How do you use a concrete finishing machine

Centrifugal barrel finishing requires the use of the right tumbling media. The cycle time for parts can be doubled if the media is not right, especially if it's the wrong geometry. If you are not using cones or cylinders to tumble media, it can significantly slow down the processing time.

The FC 10 Automatic Collator can be described as one of the most versatile and flexible collators currently on the market. It's reliable and easy-to-use, interfaces well with a number of bookletmakers, such as the Gulf States Saw & Machinery Co., Inc. Scrams, and SF2 series.

How do you use a concrete finishing machine
Material Finish Machine Zig Zag

Material Finish Machine Zig Zag

A medical device manufacturer had two major challenges in designing a citric passingivation solution. They could not use a fully-automated passivation solution. This system required data tracking to ensure quality control. Semi-Automated [...]

The use of a centrifugal barrel-finishing machine improves consistency and quality. Handwork yields only a 20% acceptance rate. But, with a centrifugal finisher, you can get much higher acceptance rates. Aside from being consistent in all directions, the surface finish following centrifugal part tumble is also isotropic. This is a big advantage over hand polishing.

Finishing Industrial Machines

With our machines, you benefit from a longer lifespan, reduced costs, and less frequent maintenance for finishing or deburring.

The speed of a centrifugal barrel totumbling machine can be controlled by the operator. This level of control allows the operator to finely finish and polish at lower speeds, while aggressive deburring can be achieved at higher speeds.

Metal Working
Metal Working

Barrel tumblers create sliding friction by using rotary movement and abrasive-tumbling media. Think of putting rocks into a container and rolling it downhill. The parts are pushed against the media or other parts, and this is called deburring.

Reduce the mess. Regularly clean the sludge. Here's a tip: Place horse bedding in the tank to absorb any remaining water. This makes it easier to use a shovel to remove the remaining sludge.

Automotive Industry

Contact us today to find out more about our dry metal machines.

A centrifugal barrel part tumbler can reduce 95% of the work required to deburr or polish parts by hand. This reduces the amount of manual sorting and greatly increases production and returns on investment. The use of a centrifugal finisher to remove and identify any defects or burrs from each piece reduces the time and cost of using a microscope.

Frequently Asked Questions

Finishing operations, also known as finishing manufacturing, occur at the end of the manufacturing process, after the part has been formed and secondary processes have been completed.

The law of attraction between positively and negatively charged particles underpins the finishing technique of applying a coating to a metal surface. The paint is usually positively charged, while the support to be painted is negatively charged because it is wired to a strong electric field.

The Inovatec Automatic Surface Finishing Machine has a PLC control system that allows you to control the entire surface finishing process. It is a completely automated and labor-saving solution. Suitable for deburring and polishing a large batch of small parts at once.