Gulf States Saw & Machinery Co., Inc. is able to manufacture tube lasers for customers, allowing them to eliminate manual processes and maximize the cutting process.
Cameras are being used by machinery manufacturers to inspect tubes. The quality check takes only about half an second, and the rotations required are reduced. This allows the machine's productivity to be maintained as well as its accuracy.
Fiber lasers achieve high cutting speeds in thin material thicknesses. Additionally they boast low power consumption while requiring little maintenance.The special properties of this laser cutting technology enable applications insteel, stainless steel, aluminum, and non-ferrous metals, such as copper andbrass.
Laser systems for electronics manufacturing are fast and high-precision and can be used to cut, mark, weld, mark, or ablate metals and other materials.
Motion Dynamics, a world-class manufacturer of neurological parts, includes steerable catheters or "pullwire" assemblies. Motion Dynamics also makes use of StarCut Tubes for precision cutting key components.
Material loading and unloading automation is an important topic in sheet laser cutting. It offers many options and complexity. Tube laser cutting systems fitted with vertical storage systems (for tubes and section bar) that can handle bars automatically and allow for unmanned production adjustments have only been available for a short time.
The CO2 solution to large-diameter tubes and profiles Tubes up O14" / 24", (355 mm, 610 mm).3D cutting modeCO2 laser
The subject of material loading and unloading automation is well established in sheet laser cutting with a multitude of solutions and complexity. In contrast, tube laser cutting systems equipped with vertical storage systems, for tubes and section bars, capable of handling bars automatically and allowing for unmanned production changes have only been available for a few years.
Monaco high-power Femtosecond Lasers offer exceptional edge quality in micromachining, and improves in scientific applications such three-photon Microscopy.
You should also consider the shortcase-sized modules of the fiber laser. They provide redundancy. The resonator will not shut down completely if one of the modules has a problem. The fiber laser works in redundant mode so that the other modules can provide more power temporarily to sustain the down module's needs until they can be repaired. Field repairs are possible, however. Sometimes the fiber laser can produce less power while repairs are being made. An issue with a CO2 Resonator will cause the entire system to fail.
Learn how the Coherent StarCut Tube was used to cut stents and how StarFiber, a laser-powered cutting machine, helped NPX Medical.
Parts can be held with automatic tabbering (in FabCreator), as well as a set of jaws at the drive chuck, and the idler-chuck.
The most productive solution to tubes of any section. Tubes upto O 6" (152.4mm).2D cutCO2 (or fiber laser).
Some things are very obvious. A fiber laser's laser generator is smaller than a CO2 resonator. The fiber laser is actually made from banks of diodes, which are assembled in a module the size of a briefcase. It can produce power from 600 to 1,500 Watts. The final powered resonator is made up of multiple modules that are connected together. It can be as small as a small filing cabinet. Fiber-optic cable amplifies the light produced and channels it. The light that exits the fiber optic cable is exactly the same as it was when it was generated. There is no loss in power or quality. The light is then focused and adjusted to determine the material that will be cut.
Modern CO2 machines typically generate the laser beam in a sealed glass tube filled with gas, typically carbon dioxide. A high voltage flows through the tube, interacting with the gas particles and increasing their energy, resulting in the production of light.
Pipe and tubing Cutting Procedures:
Rotate the pipe cutter around. Tighten the cutter slightly and rotate it around the pipe several times. Repeat until the pipe is severed by the blade. Steel pipe can be cut with a hacksaw, reciprocating saw, or steel-pipe tubing cutter.